TP-Link TD-W8962ND User Manual page 38

TD-W8962ND
Authentication Method: Select the Authentication Method from the drop-down list, the
default method is AUTO_AUTH, and you can leave it as a default setting.
Choose the right connection type according to your needs: For PPPoE connection, you
can select Connect on demand or Connect automatically or Connect manually. Connect
on demand is dependent on the traffic. If there is no traffic (or Idle) for a pre-specified period
of time), the connection will tear down automatically. And once there is traffic send or receive,
the connection will be automatically on.
Click Advanced, advanced selections for WAN Service Setup can be shown.
Service Name/Server Name: Enter the Service Name and Server Name if it was provided by
your ISP. You can leave them blank, if the ISP doesn't provide them.
4.5.1.4 PPPoA
If your ISP provides a PPPoA connection and you need to use an ATM Interface, choose PPPoA
in the drop-down list, and then the screen will be displayed as below.
The configuration is similar to PPPoE. Please refer to the section
part.
4.5.1.5 IPoA
If your ISP provides an IPoA connection, select IPoA option for the WAN service type on the
screen.
300Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-8
29
4.4.14 PPPoE to configure this