Room 2 Source Playback - Sherwood RD-7405HDR Operating Instructions Manual

RD7405(A)100225_RD7405(A).qxp 2010-03-09 오전 9:47 페이지 28

ROOM 2 SOURCE PLAYBACK

• This function allows enjoying one source in the main room and playing another in a different room at the same
time.
■Notes:
• The digital audio signals cannot be heard in the different room(ROOM 2).
Therefore, to hear the sound from the ROOM 2 source, make the analog audio connection between components.
• Even when this receiver enters the standby mode, in such a case that only the "R2" lights up still, meaning only
the ROOM 2 circuitry operates, the ROOM 2 source can be played independently.
• When you do not use the ROOM 2 function, turn off the ROOM 2 function to save electricity.
1.
Press the ROOM 2 button to enter the ROOM 2
mode.
• ROOM 2 ~ is displayed for several seconds.
• When the ROOM 2 setting mode disappears,
press the ROOM 2 button again.
2.
Select the desired mode while displaying the
ROOM 2 setting mode.
Each time these buttons are pressed, the mode
•
changes as follows :
→ ROOM 2 ~ : To turn on or off the ROOM 2 function.
(ROOM 2 mode)
↕
IN ~ : To select the desired ROOM 2 source.
(ROOM 2 input)
↕
→ VOL ~
: To adjust the volume on the power
amplifier assigned to "R2".
(ROOM 2 volume)
■Note :
• When the ROOM 2 mode is set to OFF, the
ROOM 2 input and the ROOM 2 volume cannot be
selected.
3.
Set the selected mode as desired.
■When selecting the ROOM 2 mode.
ON : To turn on the ROOM 2 function.("R2" lights up.)
↕
OFF : To turn it off. ("R2" goes off.)
■When selecting the ROOM 2 input.
• You can select the desired among MAIN source,
TUNER, CD, TAPE, AUX 1~AUX 2, VIDEO 1 ~
VIDEO 2 as a ROOM 2 source.
■When selecting the ROOM 2 volume.
• You can adjust the volume on the power amplifier
assigned to "R2" when the ROOM 2 speaker
terminals are connected to the speakers in a
different room. (For details, refer to "When selecting
the AMP ASSIGN" on page 31.)
4.
Start play on the component related to the
ROOM 2 source.
28