Sherwood RD-7405HDR Operating Instructions Manual page 18

RD7405(A)100225_RD7405(A).qxp 2010-03-09 오전 9:47 페이지 18
When adjusting the sound parameters
• While playing digital signals from Dolby Digital program source or listening in Dolby Pro Logic II Music mode or
Dolby Pro Logic IIx Music mode, you can adjust their parameters for optimum surround effect.
1.
Press the SOUND PARAMETER button.
• Then "DRC ~ " (or "PANO ~ ") is displayed.
• If the parameter mode disappears, press this button
again.
3.
Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to adjust the selected parameter as desired.
■When selecting the "PANO (Panorama)" mode
This mode extends the front stereo image to include the surround speakers for an exciting "wraparound" effect with side
wall imaging. Select "OFF" or "ON"(default value: OFF).
■When select
ing the "CWIDTH (Center width)" control
This adjusts the center image so it may be heard only from the center speaker, only from the left/right speakers as a
phantom image, or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7(default value : 3).
■When selecting the "DIMEN (Dimension)" control
This gradually adjusts the soundfield either towards the front or towards the rear. The control can be set in 7 steps from
-3 to +3 (default value : 0).
4.
Repeat the above steps 2 and 3 to adjust other parameters.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired parameter.
• Each time these buttons are pressed, the parameter
mode changes as follows:
→ "DRC" ↔ "PANO" ↔ "CWIDTH" ↔ "DIMEN"←
(Dynamic Range (Panorama)
Compression)
• "DRC" can be selected only while playing digital
signals from Dolby Digital source.
• "PANO", "CWIDTH" and "DIMEN" can be selected only
while listening in Dolby Pro Logic II Music or Dolby Pro
Logic IIx Music mode.
■When selecting the "DRC (Dynamic Range
Compression)" mode
This function compresses the dynamic range of
previously specified parts of Dolby Digital sound track
(with extremely high volume) to minimize the difference
in volume between the specified and non-specified
parts. This makes it easy to hear all of the sound track
when watching movies at night at low levels. The DRC
mode can be set in 11 steps from 0.0 to 1.0 (default
value : 0.0).
■Note : In some Dolby Digital softwares, the DRC
mode setting may not be valid.
18
(Center width) (Dimension)