Room 2 Source Playback - Sherwood Newcastle R-863 Operating Instructions Manual

ROOM 2 SOURCE PLAYBACK

This function allows enjoying one source in the main room and playing another in a different room at the same
time.
The analog signals from the 7.1 CH DIRECT inputs and TAPE MONITOR INs as well as the digital signals
from the coaxial or optical digital input cannot be output from the ROOM 2 OUTs, meaning no playback in a
different room.
When you connect the multi - room adapter to the MULTI - ROOM jack of this unit, you can control this unit
with its remote control unit in a different room, too. (For details, refer to "CONNECTING MULTI - ROOM
SYSTEM KIT" on page 8.)
Press the ROOM 2 button.
1
ROOM2 FEED
or
Select the desired input as a ROOM 2
2
source while "R2" is flickering.
AUDIO VIDEO
or
TUNER
Start play on the component related to the
3
ROOM 2 source.
DVD
VOL. CH LEVEL
CH SEL
ENTER
RPT INTRO
A B
TITLE
7.1 SURR RETURN
AUTO
DSP
MODE
ST
DISC TEST CENTER
P.SCAN TONE MODE
TUNER CD T1/MON AUX PHONO
VID1 VID2 VID3 VID4 VID5
ROOM2
SYS DISP SLEEP DIRECT IN ROOM2
HOME THEATER MASTER
RNC-220
DVD
VOL. CH LEVEL
CH SEL
ENTER
RPT INTRO
A B
TITLE
RETURN
7.1 SURR
AUTO
DSP
MODE
ST
DISC TEST CENTER
CD AUX
P.SCAN TONE MODE
TUNER CD T1/MON AUX PHONO
VID1 VID2 VID3 VID4 VID5
VID1 VID2 VID3 VID4
SYS DISP SLEEP DIRECT IN ROOM2
HOME THEATER MASTER
RNC-220
"R2" will flicker for 3 seconds and the ROOM 2
function is activated.
To cancel the ROOM 2 function, press it again.
Then "R2" goes off
You can cancel the ROOM 2 function with using
these buttons even in the standby mode.
The selected ROOM 2 source is displayed for 3
seconds as follows : (R2) TUNER, (R2) CD, (R2)
AUX, (R2) VIDEO 1~4.
Only these sources can be played in another room.
When an audio program source is selected, as a
ROOM 2 source, the image of the video program
source selected previously can be played separately,
too.
(For details, refer to "SETTING THE ROOM 2
FEED SETUP"on page 44.)
Only while "R2" is flickering, the volume level for
the ROOM 2 source can be adjusted.
When "R2" is not flickering and lights up, press the
ROOM 2 button again briefly twice.
Notes:
Even when this unit enters the standby mode, in
such a case that "R2" lights up still and the
STANDBY button lights up in blue as it does in the
operating mode, meaning only the ROOM 2 circuitry
operates, the ROOM 2 source selected previously
can be played independently.
When you do not use the ROOM 2 function, cancel
the ROOM 2 function to save electricity.
For ROOM 2 volume adjustment, refer to "SETTING
THE ROOM 2 FEED SETUP" on page 44.
31