Sherwood RD-7405HDR Operating Instructions Manual page 7

RD7405(A)100225_RD7405(A).qxp 2010-03-09 오전 9:47 페이지 7
3.
CONNECTING AUDIO COMPONENTS
• The TAPE IN/OUT jacks can be connected to audio recording equipment such as a tape deck, an MD recorder,
etc.
4.
CONNECTING DIGITAL INS
• The OPTICAL and the COAXIAL DIGITAL OUTs of the
components that are connected to CD and VIDEO 1 ~
VIDEO 2 of this unit can be connected to these DIGITAL
INs.
• A digital input should be connected to the components
such as a CD player, DVD player, etc. capable of
outputting Dolby Digital or PCM format digital signals,
etc.
• For details, refer to the operating instructions of the
component connected.
• When making the COAXIAL DIGITAL connection, be
sure to use a 75 Ω COAXIAL cord, not a conventional
AUDIO cord.
• Some of the commercially available optical fiber cords cannot be used for the equipment. If there is an optical
fiber cord which cannot be connected to your equipment, consult your dealer or nearest service organization.
■Note :
• Be sure to make either a OPTICAL or a COAXIAL DIGITAL connection on each component. (You don't need to
do both.)
■Digital input default settings
• If you connect the DIGITAL INs to your components, it is easier to do so following the default settings.
• If your DIGITAL connections are different from default settings, you should assign the DIGITAL INs you used
with the "When selecting the DIGITAL IN" procedure on page 33.
• The default settings are as follows :
OPT IN : VIDEO 1, COAX-1 IN : VIDEO 2, COAX-2 IN : CD
7