Position And Level The Unit; Dryer And Exhaust Duct Clearances - Speed Queen Stacked Washers and Dryers Installation Instructions Manual

Step 2: Position and Level the Unit
Position unit so it has sufficient clearance for
installation and servicing. Refer to Figure 2.
A
Area
A Left Dryer Side
B Right Dryer Side
C Dryer Top
D* Dryer Rear
E Exhaust Duct Clearance to Combustible Materials
*Rear clearance is minimum. Six inches are recommended when venting through rear of unit.
NOTE: Shaded areas indicate adjacent structure.
NOTE: Use of the dispenser drawer or unit doors
as a handle in the transportation of the unit may
cause damage to the dispenser or doors.
Place unit in position on a solid, sturdy and level floor.
Installing the unit on any type of carpeting, soft tile, a
platform or other weakly supported structures is not
recommended.
6
B

Dryer and Exhaust Duct Clearances

Description
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
0 in. (0 cm)
1 in. (2.54 cm)
6 in. (15.24 cm)
4 in. (10.2 cm)
2 in. (5.1 cm)
Figure 2
C
D
E
E
SWD795N
Minimum Clearance
SWD795N
802714R5