Reassembly; Position Unit Near Installation Area - Speed Queen Stacked Washers and Dryers Installation Instructions Manual

Reassembly

1. Lift dryer and place it on top of washer so dryer
leveling legs sit in notches in control cabinet.
2. Slide dryer backward until mounting holes in
base line up with holes in front of security
cabinet.
3. Replace two 7/16 inch screws and washers
holding dryer to washer.
4. Reconnect dryer wire harness. If needed, refer to
unit's wiring diagram.
5. Reattach the control panel to the control cabinet
using four screws.
6. Replace dryer's front access panel.
802714R5
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
Step 1: Position Unit Near Installation
Area
Move unit as close to the desired area of installation as
possible.
CAUTION
Washer and dryer are not designed to be
operated as separated, side-by-side units.
The stack washer/dryer must be installed on a ground
or basement floor, preferably concrete. If the flooring
is wood construction, the flooring must meet a static
load rating of 125 pounds and a maximum dynamic
load rating of 170 pounds per foot. If the existing floor
does not meet the dynamic load rating, the floor must
be re-enforced from below to meet the specification
(maximum span = 16 feet, 2x10 joists, 16 inches on
center, 1 inch sub floor).
The stack washer/dryer must be installed on a smooth,
non-slip surface. Un-level tile and extremely slippery
surfaces should be avoided. Do not install the washer
on carpeting, soft tile, a platform or other weakly
supported structures.
Failure to meet the minimum floor load and surface
requirements or installing the products on above
ground floors can create different levels of vibration or
movement that may appear like service is required.
Speed Queen will not cover scheduled repair services
where the installation requirements are not per
specifications, nor can products be returned to the
authorized dealer in these cases.
W187
5