Before You Start; Supplies; Parts Included; Removing Dryer - Speed Queen Stacked Washers and Dryers Installation Instructions Manual

Before You Start

Supplies

For most installations, the basic supplies you will need
are:
1
5
4
8
9
1 Safety Glasses
2 Wood Block
3 Power Cord (Electric Models)
4 Wrench
5 Screwdriver
6 Level
7 5/16 Inch Socket Wrench
8 Duct Tape
9 Teflon Tape (Gas Models)
Figure 1
WARNING
Any disassembly requiring the use of
tools must be performed by a suitably
qualified service person.
4
3
2
6
7
DRY2023N
W299
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Parts Included

An accessories bag has been shipped inside your unit.
It includes:
• Installation Instructions
• Two User's Guide (one for washer and one for
dryer)
• Warranty Bond
• Three screws (electric dryers only). Refer to
Connecting Power Cord sections in Step 5 of
Installation.
• Two fill hoses with washers and filter screens.
Refer to Step 2 of Installation.
• Four rubber feet. Refer to Step 7 of Installation.
• Beaded strap. Refer to Step 3 of Installation.
NOTE: If the unit is delivered on a cold day (below
freezing), or is stored in an unheated room or area
during the cold months, do not attempt to operate
it until the unit has had a chance to warm up.
NOTE: Some moisture in the wash drum is normal.
Water is used during testing at the manufacturer.

Removing Dryer

Use the following steps if the installation requires
removal of the dryer. Two people are required to
perform this task.
1. Remove dryer front access panel.
2. Remove four screws holding control panel to
control cabinet.
3. Disconnect dryer control wire harness from main
dryer wire harness.
4. Remove two 7/16 inch screws and washers
attaching dryer to washer.
5. Slide dryer forward until rear leveling legs slide
into notches in the control cabinet.
6. Lift dryer and place it on a level surface.
802714R5