Connect Drain Hose To Drain Receptacle; Drain Flow Rate; Standpipe Installation; Wall Installation - Speed Queen Stacked Washers and Dryers Installation Instructions Manual

Step 4: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by unhooking the hose from the
retainer clamp and by removing the shipping tape.
Install the drain hose into the drain receptacle
(standpipe, wall or laundry tub) following the
instructions below.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 1-1/4 inch (32 cm) outside
diameter drain hose.

Drain Flow Rate

Drain Height
3 ft. (0.9 m)
5 ft. (1.5 m)
6 ft. (1.8 m)
7 ft. (2.1 m)
8 ft. (2.4 m)

Standpipe Installation:

Place the drain hose into the standpipe.
Remove the beaded strap from accessories bag and
place around standpipe and drain hose and tighten
strap to hold hose to standpipe. Refer to Figure 8. This
will prevent the drain hose from dislodging from drain
receptacle during use.
10
Flow Rate
gallons per minute
(liters per minute)
8.19 (31)
7.27 (27.5)
6.31 (23.9)
4.89 (18.5)
2.79 (10.6)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
1
24 in. to 36 in.
(61 to 91.44 cm)
Recommended
Height
2
3
1 Drain Hose
2 Beaded Tie-Down Strap
3 Standpipe 2 in. (5.08 cm) or 1-1/2 in. (4 cm)
Figure 8

Wall Installation:

For installations of this type, the drain hose MUST be
secured to one of the fill hoses using the beaded strap
from accessories bag. Refer to Figure 9.
NOTE: End of drain hose must not be below 24 in.
(61 cm).
1
2
3
1 Drain Hose
2 Beaded Strap (tape if necessary)
3 Fill Hoses
Figure 9
SWD598N
SWD598N
H023I
802714R5