Speed Queen Stacked Washers and Dryers Installation Instructions Manual page 7

Place a level on the cabinet top and check if the unit is
level from side to side and front to back.
NOTE: Level must rest on raised portion of top
panel. Refer to Figure 3.
5
4
3
1 Level
2 Rubber Foot
3 Leveling Leg
4 Locknut
5 Unit Base
Figure 3
If unit is not level, tilt unit to access the front and rear
leveling legs. For easier access to leveling legs, prop
up unit with a wooden block. Refer to Figure 4.
Loosen the locknuts and adjust legs by screwing into
or out of unit base.
802714R5
1
2
S
SWD833N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
1
1 Wood Block
Figure 4
Make sure that the unit does not rock. When unit is
level and does not rock, tighten locknuts securely
against bottom of unit base. If these locknuts are not
tight, unit will move out of position during operation.
All four legs must rest firmly on the floor so the
weight of the unit is evenly distributed. The unit must
not rock and must be level from side-to-side and front-
to-back.
NOTE: Do not slide unit across floor once the
leveling legs have been extended. Legs and base
could become damaged.
Place rubber feet (supplied in accessories bag) on all
four leveling legs. Refer to Figure 3.
Verify that unit does not rock.
SWD832N
7