Installing Transceivers; Installing Fan Trays - Alcatel-Lucent OmniSwitch 10K Getting Started Manual

Note. Do not force the module into the slot. If any
resistance is encountered, make sure the module is aligned
properly in the card guides.
2 When the module is nearly seated in the slot, be sure
that the two extractor levers—one on top of the module
and one on the bottom—are open (approximately 90
degrees). This allows the notch on each extractor lever to
grasp the rail on the chassis.
3 Once the notches have grasped the rail, press both
extractor levers inward simultaneously until the module is
firmly seated.
4 Once the module is firmly seated, secure the module to
the chassis by tightening the two captive screws.
8 Installing the Hardware

Installing Transceivers

For detailed information on installing transceivers, refer to the
OmniSwitch AOS Release 7 Transceivers Guide.

Installing Fan Trays

1 Insert the tray into the chassis slot and slide it straight
back until it meets the chassis backplane connectors.
2 When the fan tray is firmly seated, tighten the two
captive screws at the left and right sides of the fan tray's
front panel.
October 2010