Changing The Login Password; Setting The System Time Zone; Setting The Date And Time - Alcatel-Lucent OmniSwitch 10K Getting Started Manual

Changing the Login Password

Change the login password for admin user sessions by
following the steps below:
1 Be sure that you have logged into the switch as user
type admin (see "Logging In to the Switch" on page
2 Enter the keyword password and press Enter.
3 Enter your new password at the prompt.
Note. Be sure to remember or securely record all new
passwords; overriding configured passwords on
OmniSwitch 10K switches is restricted.
4 You will be prompted to re-enter the password. Enter
the password a second time.
New password settings are automatically saved in real time to
the local user database; the user is not required to enter an
additional command in order to save the password
information. Also note that new password information is
retained following a reboot. All subsequent login sessions,
including those through the console port, will require the new
password to access the switch.
For detailed information on managing login information,
including user names and passwords, refer to the OmniSwitch
AOS Release 7 Switch Management Guide.
16 Your First Login Session

Setting the System Time Zone

The switch's default time zone is UTC. If you require a time
zone that is specific to your region, or if you need to enable
Daylight Savings Time (DST) on the switch, you can
configure these settings via the system timezone and
13). system daylight-savings-time commands.
For detailed information on configuring a time zone for the
switch, refer to the OmniSwitch AOS Release 7 Switch
Management Guide.

Setting the Date and Time

Set the current time for the switch by entering system time,
followed by the current time in hh:mm:ss.
To set the current date for the switch, enter system date,
followed by the current date in mm/dd/yyyy.
October 2010