Booting The Switch; Component Leds - Alcatel-Lucent OmniSwitch 10K Getting Started Manual

Booting the Switch

Now that you have installed the switch components and
connected network and management cables, you can boot the
switch. To boot the switch, plug all power supply cords into
easily-accessible, properly grounded power outlets. (Do not
use extension cords.) The switch will power on and boot
automatically.
Note. If you have more than one power supply installed,
be sure to plug in each power supply in rapid succession,
(i.e., within a few seconds of each other). This ensures that
there will be adequate power for all modules throughout
the boot process.

Component LEDs

During the boot process, component LEDs will flash and
change color, indicating different stages of the boot. Following
a successful boot, the LEDs on all switch components,
including power supplies, should display as follows:
CMM OK1
CMM OK2
CMM CONTROL
CMM FABRIC
CMM TEMP
12 Booting the Switch
Solid Green
Blinking Green
Solid Green
Solid Green
Solid Green
CFM OK1
CFM OK2
NI OK1
NI OK2
Power Supply AC
Power Supply DC
Note. If a secondary CMM is installed in the chassis
(typically in slot B), its CMM CONTROL LED should be
blinking green.
If the LEDs do not display as indicated, make sure the boot
process is completed. If the LEDs do not display as indicated
following a complete boot sequence, contact Alcatel-Lucent
Customer Support. For information on fan tray LED states,
refer to the OmniSwitch 10K Hardware Users Guide.
Once the switch has completely booted and you have accessed
your computer's terminal emulation software via the console
port, you are ready to log in to the switch's Command Line
Interface (CLI) and configure basic information. Continue to
"Your First Login Session" on page
Solid Green
Blinking Green
Solid Green
Blinking Green
Solid Green
Solid Green
13.
October 2010