Advertisement
Hyundai Elantra (Double DIN) 1996-2000
1
Disconnect the negative battery terminal to pre-
vent an accidental short circuit. Pop out the dim-
mer switch panel and remove (1) Phillips screw
exposed. Unsnap the gear shifter trim plate and
remove (1) Phillips screw exposed at the base of
the dash trim bezel. Reach under the driver's
side dash, locate the temperature control cable
and remove the cable from the white plastic
bracket. Position the gear shifter in low, pull the
dash panel away and disconnect all wiring har-
nesses. Remove the trim bezel (the temperature
controlcable will be attached). Remove (4)
Phillips screws securing the factory head unit
and disconnect the wiring. (Figure A)
2
Attach Spacer 1L and 2L to the left mounting
tabs of the Radio Housing and Spacer 1R and 2R
to the right mounting tabs of the Radio Housing
as shown. Skip to the Installation Instructions
for ALL VEHICLES on Page #3. (Figure B)
Hyundai Santa Fe 2001-2006
1
Disconnect the negative battery terminal to pre-
vent an accidental short circuit. Remove ashtray
and (2) Phillips screws exposed in cavity.
Unsnap and remove climate controls with cau-
tion. The climate controls have (2) clips that con-
nect with the radio bezel. Remove (2) phillips
screws now exposed under radio bezel (facing
up). Unsnap the bottom of the radio bezel, then
the top and pull straight back. Remove (4)
phillips screws and remove pocket from bezel.
Remove (4) Phillips screws to remove radio from
dash. (Figure A)
2
Attach Spacer 3L and 4L to the left mounting
tabs of the Radio Housing and Spacer 3R and 4R
to the right mounting tabs of the Radio Housing
as shown. (Figure B)
NOTE: In cars with factory single DIN radio and pock-
et, you may have to file the inside edge of the facto-
ry bezel.
99-7309 DASH DISASSEMBL Y
1
A
B
"1L"
"2L"
A
B
"3L"
"3L"
"1R"
"2R"
"3R"
"4R"
Advertisement
