Removing The Motherboard Or Bottom Case (Hp Authorized Service Providers Only) - HP Pavilion xz200 Service Manual

Removing the Motherboard or Bottom Case
(HP Authorized Service Providers Only)
Required Equipment
•
#0 Phillips screwdriver.
•
.5 mm hex driver
When Installing a New Motherboard
Before replacing the motherboard, you must (if possible) electronically store the motherboard's serial
number and service ID for transfer to the new motherboard.
1. Exit Windows and boot to a DOS prompt.
2. Run ESN.EXE from one of these sources:
•
On a factory software installation, change to the \hp\drivers\hputils directory and type
the prompt.
•
Otherwise, copy \hp\drivers\hputils\ESN.EXE from the Recovery CD, then run it on the
notebook.
3. Store the serial number and service ID as directed.
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove these additional assemblies:
•
Battery (page 2-4).
•
Plug-in module (page 2-5).
•
Hard disk drive (page 2-6).
•
Keyboard cover (page 2-9).
•
Keyboard (page 2-11).
•
SDRAM modules (page 2-13).
•
Mini-PCI card (page 2-16).
•
Display assembly (page 2-18).
•
Fan and heatsink (page 2-22).
•
CPU module (page 2-25).
•
Top case (page 2-27).
•
Hinge saddles (page 2-30).
3. Remove the retaining screws from the hard disk drive guide, and lift the guide off of the
motherboard.
4. Remove the retaining screw from each CD/DVD disk drive guide, and life the guides off of the
motherboard.
2-32 Removal and Replacement
at
esn
Technology Code IC)