Table of Contents
Advertisement
3 Jumpers and Switches
This chapter describes all jumpers and switches that can be modified on the Starterkit. The
default setting is shown with a grey shaded area.
3.1 MCU Operating-Mode (S5)
The DIP-switch S5 is used to set the operating mode of the MCU. Ensure that the mode pin
settings correspond to the operation-mode of the application. For more detailed information
please check the Hardware-Manual of the microcontroller.
DIP switch
S5/1 (MD0)
S5/2 (MD1)
S5/3 (MD2)
S5/4 (Not used)
Default: grey
By default, the "Single Chip Run-Mode" of MB91F467D is selected.
Dip-Switch S5
(default setting)
© Fujitsu Microelectronics Europe GmbH
SK-91F467D-208PFV V1.1
Jumpers and Switches
Setting
Logical value
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
Not connected
OFF (open)
Not connected
Table 3-1: MCU Operating Mode
MD0 MD1 MD2 nc
ON
OFF
1
2
3
4
Figure 3-1: MCU Mode Switch
- 17 -
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
FMEMCU-UG-910014-10
Advertisement
Table of Contents
