Fujitsu SK-91F467D-208PFV User Manual page 52

4) Connect Starterkit and PC with a 1:1 RS232 cable. The microcontroller MB91F467 is
using UART4 interface for serial Flash Programming.
5) Power-off the board or assert and hold RESET
6) Press "Automatic" button to start programming
By using the "Automatic" button the programming steps are automatically proceed
by the Flash Programmer Utility.
7) Power-on the board or release RESET to start Flash Programming
All steps are proceed automatically, download the Flash Programming routine, 'blank
check', Flash erase if necessary and programming the application.
Following is displayed in the message window in case of successful programming:
Sending start characters...
Connection OK.
Filesize=8192 (0x2000)
bincommand:
write
writing 8192 bytes...
received checksum = 4426 (0x114A)
calculated checksum = 4426 (0x114A)
OK - checksums match
write finished.
Sending Baudrate Information:
received checksum = 114 (0x0072)
calculated checksum = 114 (0x0072)
OK - checksums match
write byte finished.
Baudrate set (write byte) finished.
calling address 0x030000
bincommand:
"call"
call initiated - waiting for returnvalue...
returnvalue = 254
searching for flash-loader...
Flash mode activated (">" received)
Checking...
Blank Check finished
Chip erase in process...
CAUTION : DO NOT INTERRUPT OR CUT OFF POWER DURING ERASE !!!
Chip-erase successful
FMEMCU-UG-910014-10
SK-91F467D-208PFV V1.1
Flash Programming
- 52 - © Fujitsu Microelectronics Europe GmbH