Table of Contents
Advertisement
Sending download command
loading and programming...
00148000 : Secrurity Address not programmed,, use Prog Word!
00148004 : Secrurity Address not programmed, use Prog Word!
00148006 : Secrurity Address not programmed, use Prog Word!
001448008 : Secrurity Address not programmed, use Prog Word!
0014800C : Secrurity Address not programmed, use Prog Word!
0014800E : Secrurity Address not programmed, use Prog Word!
Download and programming completed
Automode finished.
COM port closed
automatically disconnect
Figure 6-2: FME Flash Programmer output message window
As shown in the message window the security address is not programmed in
Automatic programming process. This is done for security reason to avoid the
activation of the Security function by accident.
8) After successful programming assert Reset or Power off / on the board in order to
start the application.
© Fujitsu Microelectronics Europe GmbH
SK-91F467D-208PFV V1.1
Flash Programming
Note 1:
The MB91F467D series is checking the serial UART4 interface for
valid string to enter Flash programming mode. For details about
boot sequence refer to Hardware Manual of MB91460 series.
Note 2:
Be aware of Security Features of MB91F467D series. Check
documentation of MB91460 series for detailed information!
- 53 -
FMEMCU-UG-910014-10
Advertisement
Table of Contents
