Installation - Fujitsu SK-91F467D-208PFV User Manual

SK-91F467D-208PFV V1.1

Installation

2 Installation
Remove the board carefully from the shipping carton.
First check whether there are any damages before power on the Starterkit.
To supply the Starterkit, use the delivered In-Plug AC-DC Adapter (UPA 2000). Select the
AC plug adapter suitable for your country power sockets
Figure 2-1 AC plug adapter
and insert this adapter in the connection terminal on the AC-DC adapter.
Figure 2-2: AC plug adapter selection
Check the selected output DC voltage of the AC-DC In-Plug adapter at the voltage selection
key. It should be 9V! Change the output voltage only in a powered-down condition!
Figure 2-3: DC voltage selection
Select the low voltage adapter suitable to the power connector X5 at the SK-91F467D-
208PFV and plug it to the connecting socket in the right orientation ('+' connected to shield
and 'GND' connected to centre pin).
Figure 2-4: Low voltage adapter selection
Now connect the DC low voltage adapter to the Starterkit and plug in the In-Plug Power
Supply to a power socket. The SK-91F467D-208PFV can be turned on with the on board
power switch S8 (or S9).
FMEMCU-UG-910014-10 - 12 - © Fujitsu Microelectronics Europe GmbH