Jumpers And Switches; Operating Mode (S2) - Fujitsu SK-96390-100PMC User Manual

2 Jumpers and Switches

This chapter describes all jumpers and switches that can be modified on the evaluation
board. The default setting is shown with a grey shaded area.

2.1 Operating Mode (S2)

This switch controls the MCU operation mode after Reset.
Please take care of the following mode settings:
DIP switch
(Not used)
DIP-Switch S2
(RUN Mode)
Figure 2-1: MCU mode switch: RUN mode (Fixed Vector Mode)
DIP-Switch S2
(Programming Mode)
Figure 2-2: MCU mode switch: Flash Programming mode
© Fujitsu Microelectronics Europe GmbH
SK-96390-100PMC User Guide
Chapter 2 Jumpers and Switches
ON (closed)
S2-1
(MD0)
OFF (open)
S2-2 ON (closed)
(MD1)
OFF (open)
ON (closed)
S2-3
(MD2)
OFF (open)
ON (closed)
S2-4
OFF (open)
Table 2-1: MCU Operating Mode
MD0 MD1 MD2 nc
1 2
MD0 MD1 MD2 nc
1 2
Setting Logical value
Not connected
ON
OFF
3 4
ON
OFF
3 4
- 13 -
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
UG-960017-11