Jumpers And Switches; Operating Mode (S1) - Fujitsu MB91460 SERIES User Manual

3 Jumpers and Switches

This chapter describes all jumpers and switches that can be modified on the evaluation
board. The default setting for the MB91F467R Series is shown with a grey shaded area.

3.1 Operating Mode (S1)

3.1.1 Single chip run mode (default)
DIP switch
S1/1 (MD3)
S1/2 (MD2)
S1/3 (MD1)
S1/4 (MD0)
DIP-Switch S1
(default setting)
Figure 3-1-1: MCU mode switch for single chip run
© Fujitsu Microelectronics Europe GmbH
SK-91467R-176PMC User Guide
Chapter 3 Jumpers and Switches
Setting
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
Table 3-1-1: default MCU Operating Mode
MD3 MD2 MD1 MD0
1 2 3 4
- 15 -
Logical value
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
ON
OFF
FMEMCU-UG-910053-16