Remote Control Learn Routine - Viper 5601 Installation Manual

Press and release the
main menu. Press and hold for 1.5 seconds in the main menu to exit program-
ming.
To exit the shock sensor adjustment mode from the control module:
Open an entry point or turn on the ignition, the control module emits one long
chirp exiting adjustment mode.

Remote control Learn Routine™

The system comes with two 1-way remote controls already programmed to the
system. The system can store up to 4 different remote control codes in memory.
The remote uses a Supercode Protocol and requires setup before programming
the system.
If you want to program a new remote to the system follow the procedures
below.
To enter the remote setup on the remote:
AUX
1. Hold the button on the remote until you hear it emit a long beep. The
transmit LED comes on solid (approximately 8 seconds).
2. Press and hold the
3. Next enter the remote control learn routine and choose the function for
"auto learn configuration" listed on the program grid.
After entering the setup mode on the remotes, use the following learn routine to
add remote controls to the system.
The learn routine may be locked if previously programmed using the Bitwriter®.
If the siren generates one long chirp when attempting to program the unit, the
learn routine is locked and must be unlocked using the Bitwriter® before pro-
ceeding.
The Valet/Program switch, plugged into the blue port, is used for programming.
There is a basic sequence to remember whenever programming this unit: Door,
Key, Choose, Transmit and Release.
© 2008 Directed Electronics. All rights reserved.
AUX
button any time during programming to go back to the
button and the amber Transmit LED lights up.
AUX
33