Table of Contents
Advertisement
Neutral safety switch interface
Some vehicles do not have an electrical neutral safety switch. Instead, the ve-
hicle has a mechanical neutral safety switch that physically interrupts the starter
wire and is used when the vehicle is in any drive gear. If the remote start is
interfaced before this switch, it will provide protection from starting in gear.
However, some vehicles combine the column shift mechanism and the mechani-
cal neutral safety switch into one mechanical part.
Note:
You must complete the remote start system installation before doing the
following test. Ensure that the remote start system is functioning normally. This
includes connecting to the brake as a shut-down.
➤ Testing the neutral safety switch
1.
Make sure there is adequate clearance to the front and rear of the
vehicle because it may move slightly.
2.
Make sure the hood is closed and there are no remote start shut-downs
active.
3.
Set the emergency brake.
4.
Turn the key to the "run" position, this releases the shifter.
5.
Place the car in drive (D).
6.
Place your foot directly over the brake pedal, but do not depress it. Be
ready to step on the brake if the starter engages.
7.
Activate the remote start system.
8.
If the starter engages, immediately depress the brake to shut the remote
start system down. If the starter does not engage, no additional safety
system is required.
If the starter engages and the vehicle is a General Motors product or
Dodge Dakota pickup, refer to
under the Resource tab. for an alternative shut-down method which
prevents the starter from engaging. If the vehicle is not a General Motors
product or a Dodge Dakota pickup, please call Directed Electronics
Technical Support for an alternative shut-down method.
vehicle to the customer until this feature is properly installed!
© 2008 Directed Electronics. All rights reserved.
www.directechs.com
for Document 1008
Do not return the
27
Hide quick links:
Advertisement
Table of Contents
