Heavy Gauge, 10-Pin Connector - Viper 5601 Installation Manual

to be used like a siren output with arm/disarm honks. Refer to System Features
Menu#1, Feature 10, for more information.

➤ Heavy Gauge, 10-pin connector

There are 9 heavy gauge wires coming from the large 10-pin connector. They
are used to energize the ignition circuits in the vehicle. It is crucial to ensure that
these connections are capable of handling the current demands. For this reason,
Scotch-Locks, T-taps and other such connectors are strongly discouraged.
H3/1 PINK
Connect this wire to the ignition wire in the vehicle. This wire not only supplies
voltage for the ignition line in the vehicle, it is also the ignition feed for the
security system.
H3/2 RED/WHITE
This wire is the polarity feed for the ignition 2/flex relay.
H3/3 ORANGE
Connect this wire to the accessory wire that powers the climate control system.
H3/4 VIOLET
This wire hooks up to the starter side of the starter wire in the car. This wire is
also pin 30 of the onboard starter kill relay.
H3/5 GREEN
After cutting the starter wire connect the GREEN wire to the end going to the
ignition switch. This wire is pin 87a of the onboard starter kill relay.
H3/6 RED
This wire is the polarity feed for the Ignition1 relay.
22
(+) IGNITION 1 INPUT/OUTPUT
(+) (30A) FUSED IGNITION 2 / FLEX RELAY INPUT 87
(+) ACCESSORY OUTPUT
(+) STARTER OUTPUT
(+) STARTER INPUT
(+) (30A) FUSED IGNITION 1 RELAY INPUT
© 2008 Directed Electronics. All rights reserved.