Viper 5301 Owner's Manual

Remote start keyless entry
Hide thumbs Also See for Viper 5301:

Advertisement

Quick Links

Responder LE Model 5301
Remote Start Keyless Entry
Owner's Guide
© 2008 Directed Electronics, Vista, CA
G4202V 2008-05

Advertisement

Table of Contents
loading

Summary of Contents for Viper Viper 5301

  • Page 1 Responder LE Model 5301 Remote Start Keyless Entry Owner’s Guide © 2008 Directed Electronics, Vista, CA G4202V 2008-05...
  • Page 3: Table Of Contents

    Contents Government regulations ..................5 Warning! Safety first ..................6 What’s included....................9 Important information ..................9 Your warranty...................9 Replacement remotes.................9 Responder LE 2-way remote................10 1-way companion remote.................11 Transmitter configuration................11 Out of range notification................16 System maintenance................16 Low battery indicator ................16 Remote control progamming ..............17 Multi-car control capability...............19 Locking the vehicle..................20 Unlocking the vehicle ................20...
  • Page 5: Government Regulations

    RF exposure compliance. This device is designed to be used in a person’s hands and its operating configurations do not support normal transmissions while it is carried in pockets or holsters next to a persons’ body. © 2008 Directed Electronics. All rights reserved.
  • Page 6: Warning! Safety First

    You must read this Owner’s Guide to familiarize yourself with the proper procedures regarding manual transmission remote starters. If you have any questions, ask your installer or contact Directed at 1-800-753-0600. © 2008 Directed Electronics. All rights reserved.
  • Page 7 The remote start module must be removed or the installer must properly reinstall the remote start system so that the vehicle does not start in gear. All installations must be performed by an authorized Directed dealer. © 2008 Directed Electronics. All rights reserved.
  • Page 8 This product should not be installed in any convertible vehicles, soft,or hard top with a manual transmission. Installation in such vehicles may pose certain risk. © 2008 Directed Electronics. All rights reserved.
  • Page 9: What's Included

    Replacement remotes Your system comes with one Responder LE remote control (P/N 7251) and one remote control (P/N 7152). If additional remotes are desired, please see your authorized dealer or visit www.directedstore.com to order. © 2008 Directed Electronics. All rights reserved.
  • Page 10: Responder Le 2-Way Remote

    Remove to access batteries when necessary. For more detail, see p. 16 Transmit indicator LED indicators Flashes to indicate function confirmation Note: If Keypad Lock is On, press and then press to exit. © 2008 Directed Electronics. All rights reserved.
  • Page 11: 1-Way Companion Remote

    AUX 1 AUX 2 AUX 3 A U X Function Shift* Cabin Lock Status* Runtime Temperature (2-way only) Check* request* (2-way only) (2-way only) button must be pressed and held to access state © 2008 Directed Electronics. All rights reserved.
  • Page 12 * Horn honk is an optional feature. The panic and horn honk feature is avail- able when this option is installed. Pressing more than one button simultaneously generates an Error tone and the "Function" LED turns on. © 2008 Directed Electronics. All rights reserved.
  • Page 13 Press one time, then Hold for 1.5 seconds. Feedback Screen will display current cabin temperatue. Notes Cabin temperature is displayed on the remote. LED lights turn on to indicate a range. (See p.29) © 2008 Directed Electronics. All rights reserved.
  • Page 14 Lock/Unlock cancels the parking light flashes. Smart start Command Press three-times and then press Feedback Remote start LED turns on, with 1 beep for enable or 2 beeps for disable. Notes Enables or disables the Smart Start feature. © 2008 Directed Electronics. All rights reserved.
  • Page 15 2-way responds with an error tone. Rear defogger Command Press four times, and then . (Only after remote start is on.) Feedback Remote start LED on, 1 beep. Notes Manually turns on the defogger when remote start is © 2008 Directed Electronics. All rights reserved.
  • Page 16: Out Of Range Notification

    Note: The Lock/Unlock confirmations should be programmed On,and the op- tional horn honk installed, for the system to emit any additional honks during unlocking. Ask your authorized dealer if you have any questions. © 2008 Directed Electronics. All rights reserved.
  • Page 17: Remote Control Programming

    On. Lock LED Off: The keypad lock feature is Off and the keypad does not lock. The companion remote beeps twice wthen the feature is programmed © 2008 Directed Electronics. All rights reserved.
  • Page 18 Aux LED blinking: Power saver mode (see Note below) Aux LED Off: The remote does not wake up and listen for messages from the system to extend battery life. This means the remote does not receive © 2008 Directed Electronics. All rights reserved.
  • Page 19: Multi-Car Control Capability

    The LEDs will change to indicate the car that can be operated. After you select the car number, press any command button to operate the features. The selected car remains selected until the setting is changed. © 2008 Directed Electronics. All rights reserved.
  • Page 20: Locking The Vehicle

    The vehicle unlocks without the confirmation honk. The parking lights flash two-times. The 2-way remote flashes the LED to confirm unlocking. If no unlock confirmation is received, the 2-way remote emits the © 2008 Directed Electronics. All rights reserved.
  • Page 21: Overriding The Optional Starter Kill

    If the override switch has been programmed to a new number of presses by your authorized dealer, that number should be indicated below. Override Switch number of presses ________ © 2008 Directed Electronics. All rights reserved.
  • Page 22: Using The Remote Start

    If the hood is open or if the brake pedal is pressed, the vehicle will not remote start. The remote start shuts down: When the brake pedal is pressed The hood is opened When the remote start command is sent again from a remote control When runtime expires © 2008 Directed Electronics. All rights reserved.
  • Page 23: Runtime Check

    100% runtime remaining 75% runtime remaining 50% runtime remaining 25% runtime remaining A U X When the remote start and Function LEDs are blinking, there is less than three minutes of runtime left. © 2008 Directed Electronics. All rights reserved.
  • Page 24: Manual Transmission Vehicles

    Insert the ignition key and turn it to the On position. Now, step on the brake. The remote control plays the remote start shutdown tone. You have now taken direct control from the remote start system. © 2008 Directed Electronics. All rights reserved.
  • Page 25: Timer Mode

    flash 4 times when exiting timer mode. To exit timer mode with the transmitter: Press the button twice and then press . The parking lights flash slow four times to confirm timer mode is exited. © 2008 Directed Electronics. All rights reserved.
  • Page 26: Turbo Timer Mode

    Note: The 1-way remote only flashes the parking lights and does not emit any sounds. Turn Off the ignition. The car remains running. Exit the vehicle and Lock the system. The vehicle remains running for the programmed run time. © 2008 Directed Electronics. All rights reserved.
  • Page 27: Smart Start Activation

    The factory setting for temperature high is 100º, and the low is 0º (F). The voltage setting is 10.5v. These settings can be adjusted or turned off by your installer using the Bitwriter. © 2008 Directed Electronics. All rights reserved.
  • Page 28 Perform the same steps to activate Smart Start mode Turn the ignition On to deactivate manually Press the brake pedal The parking lights flash 5 times slowly to confirm the remote has exited Smart Start mode. © 2008 Directed Electronics. All rights reserved.
  • Page 29: Cabin Temperature

    To manually activate the rear defogger after remote start is on: Press four times, and then press Note: if remote start is not active, the remote emits an error tone. © 2008 Directed Electronics. All rights reserved.
  • Page 30: Valet Take-Over

    After you exit the vehicle you can lock the system with the remote and the car remains running. If the vehicle shuts down when locking, then the unit did not enter the valet take-over mode. © 2008 Directed Electronics. All rights reserved.
  • Page 31: Safety Features

    To disable the remote start, move the shutdown toggle switch to the Off position. Check with your installer for the location of the shutdown switch. Location of Shutdown Switch____________________________ © 2008 Directed Electronics. All rights reserved.
  • Page 32: Diagnostics

    Off by the installer. Unlocking Extra honks when unlocking the system is a notification that the batteries in the remote are low and need to be replaced. Important: The optional horn honk feature must be installed. © 2008 Directed Electronics. All rights reserved.
  • Page 33 flash between 5 - 8 times to indicate what caused the no start situa- tion. defeat toggle switch is off. Keep a record of the number of flashes, to assist your installer when taking the vehicle in for service. © 2008 Directed Electronics. All rights reserved.
  • Page 34: Owner Recognition

    (ignition is not turned on) for a one-hour period while the system is in Valet Mode, the status LED shuts Off. If the system remains in Valet Mode, the LED comes back on the next time the ignition is turned On, and then Off. © 2008 Directed Electronics. All rights reserved.
  • Page 35: 2-Way Remote

    Note: Comfort closure can only be used on cars that have the capability of closing the windows (and on some cars the sunroof as well) with the key cylinder in the door. © 2008 Directed Electronics. All rights reserved.
  • Page 36: Convenience Expansions

    Power Window Control: Automatic power window control is provided with the 529T and 530T systems. These can operate power windows,and can roll them up automatically when the system is Locked, roll them down, or both up and down. © 2008 Directed Electronics. All rights reserved.
  • Page 37: Glossary Of Terms

    Valet Button: A small push button switch located on your systems control center. It is used to override the starter interrupt when a remote is lost or damaged, or to enter or exit Valet Mode. © 2008 Directed Electronics. All rights reserved.
  • Page 38 © 2008 Directed Electronics. All rights reserved.
  • Page 39: Quick Reference Guide

    Silent UnLock Press one-time and then press The unlock LED flashes for one- second with no sound. Remote Start Press . The remote start LED turns on for 3-seconds and remote start tone sounds.. © 2008 Directed Electronics. All rights reserved.
  • Page 40 Turn the ignition key to the Off position. Exit the vehicle and lock the doors with the remote. The engine will remain running until the programmed time elapses or a shut-down input is received. © 2008 Directed Electronics. All rights reserved.
  • Page 41: Limited Lifetime Consumer Warranty

    Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding without limitation the siren, the remote transmitters, the associated...
  • Page 42 Authorized dealer’s company name and address Type of alarm installed Year, make, model and color of the automobile Automobile license number Vehicle identification number All security options installed on automobile Installation receipts 920-0003 06-06 © 2008 Directed Electronics. All rights reserved.
  • Page 44 The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology.

Table of Contents