Activating Your Phone - Sonim XP STRIKE IS User Manual

2. The charger port is located on the left side of the phone. To access the charger port, lift
the cover with the USB sign. Insert the 3.5mm jack/connector of the USB cable into the
port and insert the other end of the USB cable into the charger.
Alternatively, you can charge the phone with your PC. Insert the 3.5mm jack/connector
of the USB cable into the charger port of the phone and insert the other end of the cable
into a USB port on your PC.
3. If the battery is being charged when the phone is switched off, only the battery icon is
displayed (as shown in the below figure).
If the battery is being charged while the phone is switched on, you will notice that the
bars in the battery charge icon (visible on the home screen) show movement indicating
that the battery is being charged. After the phone is fully charged, the battery bars on the
display stop scrolling. At this point, you can disconnect the phone from the charger.

Activating Your Phone

Complete the following steps to activate your Sonim XP STRIKE IS.
●
If you purchased your phone at a Sprint Store, it is probably activated and ready to use.
●
If you received your phone in the mail and it is for a new Sprint account or a new line of
service, it is designed to activate automatically.

When you turn the phone on for the first time, a Contacting Network screen is
displayed. Follow the onscreen instructions to continue.

If required, PRL Update and Firmware Update screens are displayed. Complete the
onscreen instructions to update your phone.
Get Started 8