Maintenance; Moving And Leveling; Preventive Maintenance; Daily Maintenance - Star Trac SPINNER PRO+ Owner's Manual

M
aintenance
This section provides the procedures to maintain the Spinner
Moving & Leveling
To move the bike to a new location:
Lift the bike from the rear and use the front wheels (located on the front leg, below the handlebar) to roll the bike from one location to
another.
To level the bike:
Use the four leveling adjusters (located on the underside of the front and rear legs) to compensate for uneven floor surfaces.

Preventive Maintenance

Perform regular scheduled preventive maintenance procedures to maintain your Spinner
Note: Star Trac strongly recommends replacing the pedals after two years of use.
NCE
AINTENA

Daily Maintenance

The life of your Spinning product will be determined by how consistently you perform the daily maintenance procedures. Dry the
Spinning bike after each use to remove sweat and moisture. It is best to use a liquid non-abrasive cleaner diluted with water.
Wipe Down / Cleaning
To prevent the build-up of rust and other forms of corrosion, wipe down the bike at the end of each day (or preferably at the end of each
class). Raise all posts to the highest setting to expose moisture. Using an absorbent cloth, focus on all areas that perspiration can settle.
Give particular attention to the following areas:
 Handlebar
 Seat / adjustable slide for the seat
 Flywheel
 Back leg assembly
 Chain guard
 Brake knob and bolt assembly
 Pop-pins
 Leveling feet
NOTE: Never use abrasive cleaning liquids or petroleum-based solvents when wiping down the bike.
NOTE: Release all tension from the resistance knob after each use to allow for perspiration to evaporate. If bikes are used in a class
setting, the instructor may direct class participants to release all tension for the resistance knob after each use.
®
indoor cycling bikes in serviceable condition.
SPINNER PRO+ MANUFACTURED by STAR TRAC OWNER'S MANUAL |
®
indoor cycling bike in serviceable condition.
23