Testing Bike - Star Trac SPINNER PRO+ Owner's Manual

T B
esting ike
Use this checklist to perform the bike test procedure.

Recheck all the bolts and make sure they are all tightened to the proper torque specification (when indicated) and no parts are
missing.

Test the handlebar and seat post to make sure they move freely and you are able to lock in at different positions.

Check the seat to make sure it is level and tight and does not rotate around or tilt. Tighten and adjust as needed.

Test the seat slide for movement front to rear and check it by settings it at different settings.
CAUTION: The flywheel will continue to spin after you pedal and the crank arms and pedals will rotate with the flywheel.
Brake tension is adjustable using the red resistance knob in the front of the bike. Pressing down on the knob will apply the
brake if you need to stop quickly.

Adjust seat post and handlebar post to your needs (Refer to page 18-19). Ride / test the bike for proper operation according
to this owner's manual.

Pedal the bike at a moderate pace and test for proper and smooth resistance changes while varying the amount of turns on the
resistance knob.

When the testing is complete tip the bike forward using the handlebars and roll it on a smooth surface to the final location and
adjust the leveling feet so the bike is stable.
SPINNER PRO+ MANUFACTURED by STAR TRAC OWNER'S MANUAL |
17