HP 4108GL Management And Configuration Manual page 347

Displaying the Static and Dynamic VLANs Active on the Switch. The
show vlans command lists all VLANs present in the switch.
show vlans
Syntax:
For example, in the following illustration, switch "B" has one static VLAN (the
default VLAN), with GVRP enabled and port 1 configured to Learn for
Unknown VLANs. Switch "A" has GVRP enabled and has three static VLANs:
the default VLAN, VLAN-222, and VLAN-333. In this scenario, switch B will
dynamically join VLAN-222 and VLAN-333:
Switch "A"
GVRP enabled.
3 Static VLANs:
– DEFAULT_VLAN
– VLAN-222
– VLAN-333
The show vlans command lists the dynamic (and static) VLANs in switch "B"
after it has learned and joined VLAN-222 and VLAN-333.
Figure 14-27. Example of Listing Showing Dynamic VLANs
Port-Based Virtual LANs (VLANs) and GVRP
Switch "B"
GVRP enabled.
1 Static VLANs:
Port 1: Set to
– DEFAULT_VLAN
"Learn" Mode
Dynamic VLANs
Learned from
Switch "A"
through Port 1
GVRP
14-41