HP 4108GL Management And Configuration Manual page 277

Using the Commander's Menu To Manually Add a Candidate to a
Stack. In the default configuration, you must manually add stack Members
from the Candidate pool. Reasons for a switch remaining a Candidate instead
of becoming a Member include any of the following:
I Auto Grab in the Commander is set to
I Auto Join in the Candidate is set to
Note: When a switch leaves a stack and returns to Candidate status, its
Auto Join parameter resets to
stack from which it has just departed.
I A Manager password is set in the Candidate.
I The stack is full.
Unless the stack is already full, you can use the Stack Management screen to
manually convert a Candidate to a Member. If the Candidate has a Manager
password, you will need to use it to make the Candidate a Member of the stack.
1. To add a Member, start at the Main Menu and select:
9. Stacking...
4. Stack Management
You will then see the Stack Management screen:
Figure 13-9. Example of the Stack Management Screen
2. Press [A] (for ) to add a Candidate. You will then see this screen listing
Add
the available Candidates:
HP Procurve Stack Management
HP Procurve Stack Management
No (the default).
No .
No so that it will not immediately rejoin a
For status descriptions,
see the table on page
13-48.
13-19