HP 4108GL Management And Configuration Manual page 142

Time Protocols
SNTP: Viewing, Selecting, and Configuring
Changing the SNTP Poll Interval. This command lets you specify how
long the switch waits between time polling intervals. The default is 720
seconds and the range is 30 to 720 seconds. (This parameter is separate from
the poll interval parameter used for Timep operation.)
Syntax:
For example, to change the poll interval to 300 seconds:
Disabling Time Synchronization Without Changing the SNTP
Configuration. The recommended method for disabling time synchroniza-
tion is to use the
changing your SNTP configuration.
Syntax:
For example, suppose SNTP is running as the switch's time synchronization
protocol, with
interval. You would halt time synchronization with this command:
If you then viewed the SNTP configuration, you would see the following:
Figure 8-10. Example of SNTP with Time Sychronization Disabled
Disabling the SNTP Mode. If you want to prevent SNTP from being used
even if selected by
eter), configure the SNTP mode as disabled.
Syntax:
tion to
For example, if the switch is running SNTP in Unicast mode with an SNTP
server at 10.28.227.141 and a server version of 3 (the default),
the SNTP configuration as shown below, and disables time synchronization
on the switch.
8-12
sntp poll-interval <30 . . 720>
timesync command. This halts time synchronization without
no timesync
Broadcast as the SNTP mode and the factory-default polling
(or the Menu interface's
timesync
no sntp Disables SNTP by changing the SNTP mode configura-
Disabled .
param-
Time Sync Method
no sntp changes