HP 4108GL Management And Configuration Manual page 240

Configuring for Network Management Applications
Overview
In the next example, the show snmp-server command shows that the switch
has been previously configured to send SNMP traps to management stations
belonging to the "public", "red-team", and "blue-team" communities.
Example of
Community
Name Data (See
page 12-5.)
Example of Trap
Receiver Data
Figure 12-4. Example of Show SNMP-Server Listing
Configuring Trap Receivers. This command specifies trap receivers by
community membership, management station IP address, and the type of
Event Log messages to send to the trap receiver.
N o t e
If you specify a community name that does not exist—that is, has not yet been
configured on the switch—the switch still accepts the trap receiver assign-
ment. However, no traps will be sent to that trap receiver until the community
to which it belongs has been configured on the switch.
Syntax:
For example, to configure a trap receiver in a community named "red-team"
with an IP address of 10.28.227.130 to receive only "critical" log messages:
12-10
snmp-server host
<community-str> <ip-address> [<none | all | non-info | critical | debug>]
Authentication
Trap Setting