HP 4108GL Management And Configuration Manual page 137

ii. Enter the IP address of the SNTP server you want the switch to
use for time synchronization.
Note: This step replaces any previously configured server IP
address. If you
will be using backup SNTP servers (requires use of the CLI), then
see
"SNTP Unicast Time Polling with Multiple SNTP Servers" on page
20.
iii. Press [v] to move the cursor to the
value that matches the SNTP server version running on the device
you specified in the preceding step (step ii). If you are unsure
which version to use, HP recommends leaving this value at the
default setting of
whether any change is necessary.
Note: Using the menu to enter the IP address for an SNTP server
when the switch already has one or more SNTP servers config-
ured causes the switch to delete the primary SNTP server from
the server list and to select a new primary SNTP server from the
IP address(es) in the updated list. For more on this topic, see
"SNTP Unicast Time Polling with Multiple SNTP Servers" on page
8-20.
iv. Press [>] to move the cursor to the
6.
6. In the field, enter the time in seconds that you want for a Poll
Poll Interval
Interval. (For Poll Interval operation, see table 8-1, "SNTP Parameters",
on page 8-5.)
7. Press [Enter] to return to the Actions line, then [S] (for
new time protocol configuration in both the startup-config and running-
config files.
SNTP: Viewing, Selecting, and Configuring
Server Version
3 and testing SNTP operation to determine
Poll Interval
Time Protocols
field. Enter the
field, then go to step
Save ) to enter the
8-7