HP 4108GL Management And Configuration Manual page 281

8.
9.
N o t e :
If the message
menu's Help line, then you either omitted the Manager password for the stack
containing the Member or incorrectly entered the Manager password.
You can "push" a Member from one stack to another by going to the Member's
interface and entering the MAC address of the destination stack Commander
in the Member's
Member to another stack without a need for knowing the Manager password
in that stack, but also blocks access to the Member from the original
Commander.
Using the Commander's Menu To Remove a Stack Member. These
rules affect removals from a stack:
I
I
I
To remove a Member from a stack, use the Stack Management screen.
1.
Do one of the following:
• If the stack containing the Member you are moving has a Manager
password, press the downarrow key to select the Candidate
Password field, then type the password.
• If the stack containing the Member you want to move does not
have a password, go to step 9.
Press [Enter] to return to the Actions line, then press [S] (for
complete the Add process for the selected Member. You will then see a
screen similar to the one in figure 13-9 on page 13-19, with the newly
added Member listed.
Unable to add stack member: Invalid Password
Commander MAC Address
When a Candidate becomes a Member, its
automatically set to . This prevents the switch from automatically
No
rejoining a stack as soon as you remove it from the stack.
When you use the Commander to remove a switch from a stack, the
switch rejoins the Candidate pool for your IP subnet (broadcast
domain), with Auto Join set to
When you remove a Member from a stack, it frees the previously
assigned switch number (
assignment to another switch that you may subsequently add to the
stack. The default switch number used for an add is the lowest
unassigned number in the Member range (1 - 15; 0 is reserved for the
Commander).
From the Main Menu, select:
9. Stacking...
HP Procurve Stack Management
HP Procurve Stack Management
field. Using this method moves the
Auto Join
No .
), which then becomes available for
SN
Save ) to
appears in the console
parameter is
13-23