The following is an example installation for the P642 with ISDN.
2.7
Power Up Your Prestige
At this point, you should have connected the console port, the ADSL line, the Ethernet port and the power
port to the appropriate devices or lines. You can now apply power to the Prestige by turning the switch on.
Initial Screen
Step 1.
When you power on your Prestige, it performs several internal tests as well as line initialization. After the
initialization, the Prestige asks you to press Enter to continue, as shown.
Copyright (c) 1994 - 2000 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:a0:c5:01:23:45
WAN Channel init.........done
Loading ADSL modem F/W
...................................................................................................................done
Press ENTER to continue...
Entering Password
Step 2.
The login screen appears after you press Enter, prompting you to enter the password, as shown below.
Hardware Installation & Initial Setup
Figure 2-5 P642 with ISDN
Figure 2-6 Power-On Display
Prestige 642 ADSL Bridge
2-5