AMT Datasouth Fastmark M5 Plus Series User Manual page 39

Printer
Initialization
Set Black Mark
Sensor as Media
Sensor and
Calibrate the Black
Mark Sensor
Set Gap Sensor as
Media Sensor and
Calibrate the Gap
Sensor
Document #120522 Rev-A
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
blinks. (Any green will do during the 5 blinks).
The LED color will be changed as following:
Amber red (5 blinks)
(5 blinks)
blinks) solid green
Note:
Always do gap/black mark sensor calibration
initialization.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
green blinks. (Any green/amber will do during the 5 blinks).
The LED color will be changed as following:
Amber red (5 blinks)
(5 blinks)
blinks) solid green
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
green/amber blinks. (Any red/amber will do during the 5
blinks).
The LED color will be changed as following:
Amber red (5 blinks)
(5 blinks)
solid green
blinks)
36
green
amber (5 blinks)
green/amber (5 blinks)
green/amber
amber (5 blinks)
green/amber (5 blinks)
red/amber
amber (5 blinks)
green/amber (5 blinks)
after 5 amber
green
red/amber (5
after printer
after 5
green
red/amber (5
after 5
green
red/amber (5