Printer Initialization - AMT Datasouth Fastmark M5 Plus Series User Manual

4.3 Printer Initialization

Printer initialization is used to clear DRAM and restore printer settings to defaults.
The only one exception is ribbon sensitivity, which will note be restored to default.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
do during the 5 blinks).
The LED color will be changed in the following:
Amber red (5 blinks)
green/amber (5 blinks)
Printer configuration will be restore to defaults as below after initialization.
Parameter
Speed
Density
Label Width
Label Height
Sensor Type
Gap Setting
Print Direction
Reference Point
Offset
Tear Mode
Peel off Mode
Cutter Mode
Serial Port Settings
Code Page
Country Code
Clear Flash Memory No
IP Address
Note: Always do gap/black mark sensor calibration
initialization.
Document #120522 Rev-A
after 5 amber blinks. (Any green will
green
amber (5 blinks)
red/amber (5 blinks)
Default setting
203DPI :127 mm/sec (5 ips)
300DPI: 76 mm/sec (3 ips)
8
4" (101.6 mm)
4" (101.6 mm)
Gap sensor
0.12" (3.0 mm)
0
0,0 (upper left corner)
0
On
Off
Off
9600 bps, none parity, 8 data bits, 1 stop bit
850
001
DHCP
28
green (5 blinks)
solid green
after printer