AMT Datasouth Fastmark M5 Plus Series User Manual page 19

5. Feed the label, printing side facing up, through the paper guides and place it on
top of the platen.
6. Thread the label through the liner opening, which is beneath the roller and
tear off one piece of the label.
7. Adjust the paper guides by moving left or right to fit the label/backing width.
Roller
Fig. 20 Load label into peeler roller assembly
8. Lift the peel-off panel up and back into the closed position.
9. Close the top cover by lifting up the top cover support and
slowly.
Note: Pull the label outward removing slack after closing the top cover.
Fig. 21 Complete label installation for peel-off mode
Document #120522 Rev-A 16
Top Cover
Top Cover Support
Peel-off panel
close the top cover