Adjustments - Furuno RD-50 Operator's Manual

4.6

Adjustments

After wiring all units, initialize each remote display as follows:
1. While you hold down the DISP key, press the PWR key to turn on the power.
2. Press
3. Press
4. Repeat steps 2 and 3 to set the menu items desired.
5. Press the PWR key to close the service menu and turn off the power.
Menu
UNIT Name
Serial No
PWB No
Remote Dimmer
Depth Select
Depth Position
XXXX: Serial number
XX: Program version number
Service menu
or key to select a menu item and press the ENT key.
or key to select an option and press the ENT key.
Service menu items
For serviceman.
• [Main]: Set the unit which is connected to
the dimmer controller in the daisy chain
connection as the main unit.
• [Sub]: Set the unit which is not connected
to the dimmer controller in the daisy chain
connection as a sub unit.
Select the input sentence for depth from [Au-
to], [Keel (DBK)] (Depth below keel), [Trans-
ducer (DBT)] (Depth below transducer) or
[Surface (DBS)] (Depth below surface). In the
[Auto] mode, the highest priority data is [Keel
(DBK)] and the lowest is [Surface (DBS)].
Select the mounting location of the transduc-
er from [Single], [FWD] (forward) or [AFT] (af-
ter).
XXXX
XX
Description
4. INSTALLATION
Default
[Main]
[Auto]
[Single]
4-15