Furuno RD-50 Operator's Manual page 58

4. INSTALLATION
2) Fix the DS-605 with four M10 bolts (dockyard supply).
3) Apply silicon rubber to M10 bolts as shown below.
2. Connect the power cable and the sensor signal cable to the RD-50 through the
cable glands for the DS-605.
1) Process the power cable and the sensor signal cable referring to the illustra-
tion below.
DPYCY-1.5
TTYCYS-1
4-6
340 (13.39")
310 ± 0.5 (12.20")
Apply silicon rubber. Apply silicon rubber.
M10 bolt M10 bolt
Seal washer Seal washer
Nut Nut
70
7
M4
Vinyl tape
80 (for TB3)
Shield
7
Fold back and wrap internal shield and
fix it by cable clamp.
Fixing holes
4-ø12
Cable gland
Note: Mount the unit so the cable
glands are down.
40
Vinyl sheath
Armor
Fix armor by cable clamp.
130
35
Vinyl sheath
Vinyl tape
Vinyl sheath
Armor