Driving; Before Starting; Start The Engine - Jonsered FR2216MA Operator's Manual

Before starting

IMPORTANT INFORMATION The air intake grille in the
engine cover behind the driver's seat must not be blocked
by, for example, clothing, leaves, grass or dirt. Impaired
cooling of the engine. Risk of major engine damage.
• Read the safety instructions and information concerning
the placement of controls and functions before starting.
• Perform daily maintenance before starting as set out in
the Maintenance schedule.
Adjust the seat to the required position.

Start the engine

1 Make sure that the clutch controls are pushed in, one
control for the front axle and one for the rear axle.
2 Lift up the cutting unit by pulling the lever backwards to
locked position (transport position) and apply the parking
brake.
3 Activate the parking brake. This is done as follows:
• Push down the brake pedal.
• Press in the lock button on the steering column.
• Release the brake pedal while holding the button pressed.
The parking brake lock disengages automatically when the
brake pedal is pressed.
4 With a cold engine:
16 –
English

Driving

FR 2216MA 4X4, FR 2218A 4X4
Move the throttle to position 3 (choke position). In this
position the engine is fed with a richer mixture, which
means the engine is easier to start.
FR 2216A2 4X4
Move the throttle control to the middle position.
If the engine is cold move the choke lever backwards to its
end position.
5 With a warm engine:
FR 2216MA 4X4, FR 2218A 4X4
Move the throttle in between positions 1 and 2.
1
2
3