Ending a Videoconference
To end a point-to-point videoconference
1
Press the CONNECT/DISCONNECT (
Commander.
The message "Disconnect?" appears on the monitor screen.
2
Press the V or v button on the Remote Commander to select "OK", then
press the PUSH ENTER button, or press the CONNECT/DISCONNECT
(
To end a multipoint videoconference
Operations are the same as th.ose in Chapter 8, "Ending the Multipoint
Videoconference" on page 216.
248
Starting a Videoconference Using SIP
/
) button again.
/
) button on the Remote