Appendix
Wall mounting
Mark the monitor's outline by placing tape at four points on the wall where the LCD-TV's four
1
corners' will lie when it is installed.
• When you mark the monitor's outline on the wall, make sure that the vertical and horizontal lines are made accurate
to the TV's dimension.
• Use adhesive tape that will not leave permanent marks.
Make diagonal lines from the four corners and mark their intersecting point.
2
• Diagonally stretch string and mark the intersecting point in a way that no permanent marks will be left on the wall.
Mount the bracket on the wall by positioning the bracket's mark that indicates the display's
3
centre onto the intersecting point.
• The following measurement fi gures are rough estimates. The fi gures differ according to the location where you attach
the TV.
1 Remove the screws from the stand.
4
2 Attach the bracket to the LCD-TV.
3 When adjusting the bracket's angle, adjust it before installing the TV on the wall.
• The adjusting angles of LC-40/60LX710H are 0°, 5° and 10°, however, the angles for LC-46/52LX710H are 0°, 5°, 10°,
15° and 20°.
4 Lift the TV, remove it from the stand and attach it to the bracket.
• Attach the TV by aligning the monitor's four corners with the wall markings.
• When you adjust the TV's angle, make sure to remove the monitor from the wall.
5
Remove the tape and the string from the wall.
NOTE
• The above description is for reference. Please mount the TV in a way which properly suits the location.
LC-40LX710H
When using wall mount bracket AN-37AG2+AN-37P30
On the wall bracket of AN-37AG2,
there is a letter 'B' indicating the
centre point of the TV monitor.
68
40LX710H_en.indd 68
40LX710H_en.indd 68
339.5
340
A
B
3 5 7
5 2 0
339.5
251
wall markings
tape
dimensional markings
131
46
177
2010/04/15 16:13:06
2010/04/15 16:13:06