Initial Auto Installation; Checking Signal Strength And Channel Strength - Sharp LC-40LX710H Operation Manual

Preparation

Initial auto installation

When the TV powers on for the fi rst time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
Confi rm the following before turning on the
power
• Is the antenna cable connected?
• Is the AC cord plugged in?
Press POWER on the TV.
1
• The initial auto installation wizard appears.
Setting the on-screen display language.
2
Press a / b to select the desired language,
3
and then press ENTER.
Press c / d to select "HOME" or "STORE",
and then press ENTER.
HOME
• HOME: "STANDARD" will be the default value for the "AV
mode" setting.
• STORE: "DYNAMIC (Fixed)" will be the default value for
the "AV mode" setting. If the "AV mode" is changed, the
TV will automatically switch back to "DYNAMIC (Fixed)"
when there is no further change to TV setting for 30
minutes. When selecting "STORE", press c/d to select
"Yes"or "No" to confi rm.
Press c / d to select "Digital Search" or
4
"Analogue Search" and then press ENTER.
The TV searches for, sorts and stores all
5
the receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress,
press RETURN.
NOTE
• HOME mode: Settings are optimised for normal home viewing and
energy effi ciency.
• STORE mode: Settings are designed for maximum impact in retail
store displays.
• To change the "STORE" mode to "HOME" mode, please refer to
page 61 to reset the unit.
• If you turn off the power on the TV after performing step 4, the
initial auto installation wizard does not appear. The auto installation
function allows you to execute the auto installation again from the
"Setup" menu. (See page 19.)
• The initial auto installation wizard will go off if you leave the TV
unattended for 30 minutes before searching for channels in step 5.
40LX710H_en.indd 17 40LX710H_en.indd 17
Checking signal strength and
channel strength
If you install a D-TV antenna for the fi rst time or relocate
it, you should adjust the alignment of the antenna to
receive a good reception while checking the antenna
setup screen.
1
2
3
4
5
H Power supply setting to antenna terminal
STORE
H Checking signal strength
H Checking channel strength
6
NOTE
• The values of "Signal strength" and "Quality" indicate when
to check the appropriate alignment of the antenna.
Press MENU and the MENU screen displays.
Press c/d to select "Setup".
Press b/c/d to select "View setting".
Press a / b to select "Channel settings" and
then press ENTER.
Press a / b to select "Antenna setup-
DIGITAL", and then press ENTER.
Press c/d to select "On" or "Off".
Supply voltage
Signal strength
Channel strength
On
Press a/b to select "Signal strength".
Supply voltage
Signal strength
Channel strength
CH No. 14
Signal strength
Current 0
Quality
Current 0
Press a / b to select "Channel strength", and
then press ENTER.
Supply voltage
Frequency
Signal strength
Channel strength
CH No. 22
Signal strength
Current 0
Quality
Current 0
Position and align the antenna so that the
maximum possible values for "Signal strength"
and "Quality" are obtained.
Off
Max. 0
Max. 0
4 8 2 . 0 MHz
Max. 0
Max. 0
17
2010/04/15 16:11:19 2010/04/15 16:11:19