Kyocera FS-C1020MFP+ Operation Manual page 382

Message
The indicated tray has run out of
Out of Paper: X
paper.
Out of Toner: X
The machine has run out of the
indicated toner.
Continue printing?
Please Restart The machine needs to be
Machine restarted.
The machine failed to proceed
with the print job, because tray
Remove Paper:
1 or tray 2 was specified as the
Bypass Tray
input tray but paper was set in
the bypass tray.
The fusing unit is no longer
Replace Fusing Unit
usable, and must be replaced.
The transfer belt is no longer
Replace IntTrans. Belt
usable, and must be replaced.
Replace:
The waste toner bottle is full.
Waste Toner Bottle
A reception error occurred, and
RX Comm. Error the fax could not be received
correctly.
A scanned file could not be sent
Scan (NW)
because the Ethernet cable was
Disconnected
not connected properly.
The USB cable was
Scan (USB)
disconnected while scanning
Disconnected
from a computer.
Causes
Load paper to the indicated tray. See p.94
"Loading Paper".
• Press [No] to cancel the job and
• Press [Yes] to finish printing before
Turn off the power, and then turn it back
on.
Remove paper from the bypass tray.
Contact your service representative.
Contact your service representative.
Replace the waste toner bottle with a new
one. See p.391 "Replacing the Waste
Toner Bottle".
If possible, contact the sender of the fax
and ask them to resend it.
Reconnect the Ethernet cable properly,
and then try the operation again.
Reconnect the USB cable properly, and
then try the operation again.
Error and Status Messages on the Screen
Solutions
replace the indicated print cartridge.
See p.385 "Replacing Print
Cartridges".
replacing the indicated print
cartridge.
381