Kyocera FS-C1020MFP+ Operation Manual page 378

Message
2-in-1, 4-in-1, or 2-sided copy
Cannot copy.
could not be performed
because the originals were not
Set Original to ADF
placed in the ADF.
The paper size set for the
Check Paper Size document differs from the size of
the paper in the indicated tray.
The paper type set for the
document differs from the type
Check Paper Type
of the paper in the indicated
tray.
The line could not be connected
Connection Failed
correctly.
Cover open A cover is open.
Density Sensor The machine failed to adjust
Require Cleaning color registration.
No Quick Dial entry is
Dest. is not
associated with the One Touch
Programmed
button you pressed.
Causes
• Use the ADF, even when copying a
• If you need to use the exposure glass,
Press [FormFeed] to begin printing, or
press [JobReset] to cancel the job.
Press [FormFeed] to begin printing, or
press [JobReset] to cancel the job.
• Confirm that the telephone line is
• Disconnect the telephone line from
Close the cover completely.
Clean the toner density sensor. See p.398
"Cleaning the Toner Density Sensor".
• Press a different One Touch button.
• Assign a registered destination to the
Error and Status Messages on the Screen
Solutions
single sheet.
turn off [Comb. 2 on 1], [Comb. 4 on
1], or [2 Sided Copy] under copy
settings, and then try again. See
p.245 "Copy Settings".
properly connected to the machine.
the machine, and connect a standard
telephone in its place. Confirm that
you can make calls using the
telephone. If you cannot make calls
this way, contact your telephone
company.
One Touch button. See p.169
"Registering Scan Destinations".
377