Interior Light - GE Monogram ZBD6400 Series Technical Service Manual

6000 & 7000 Series DISHWASHERS
5.2.38 Interior Light - All models except 6400 and
6500
CAUTION. Switch off electrical power supply
and turn off water supply at main or isolating
valve.
5.2.38.1 Unscrew the light lens and seal from within the
dishwasher tub.
5.2.38.2 To remove the Light Body and Holder, simply
unlatch the retaining barb clip with a medium size screw-
driver as shown below.
Unlatch barb clip with medium size screwdriver
5.2.38.3 With the barb clip released, slight pressure on the
opposite side barb clip will allow the Light Body and Holder
to be removed from the stainless steel tub. Shown below.
5.2.38.4 To access the wiring connections to the Light
Holder, prize the single barb clip (below) from the terminal
cover and lift clear the terminal cover.
Light Body and Holder
Light Lens and Seal
Terminal Cover barb clip
5.2.38.5 Remove the two 3/16" Quick Connect terminals from
the tab terminals of the light holder.
5.2.38.6 To remove the reflector from the Light Body and
Holder, simply prize the reflector retainer clips from the three
relative cut outs of the Light Body and Holder.
NOTE: The three reflector retainer clips are positioned with
two retainer clips adjacent to each side of the lamp holder,
while the third retainer is adjacent to the tip of the glass bulb
of the lamp globe.
5.2.38.7 Removal of the Light Body and Holder can be
carried out simply by releasing one of the locking nuts and
unscrewing the locking nut from the lamp holder body.
Note: The internal locking nut adjacent to the Light Lens has
a fixed position of approximately two threads projecting past
the face of the locking nut. This relationship should be
maintained for ease of removal/ reinstallation of the Light
Globe.
5.2.38.8 Reinstallation of the interior lamp assembly is a
reversal of removal and dismantling of the lamp body and
holder assembly.
5.2.38.10 On reassembly of the light lens to the light housing
the service technician is to ensure that the lens is tightened
so that it cannot be removed without a tool. Minimum torque
6 lb-ft.
5.2.38.11 Reassemble the dishwasher in reverse order.
CAUTION. Test for water leaks before leaving.
5.2.38.10 Operate and test dishwasher before leaving.
PAGE 57