One Of The Projectors Is Not Turned On, Or The Projectors Have Not Been Linked Together; Other Problems; No Sound Can Be Heard Or The Sound Is Faint - Epson EB-W16SK User Manual

Problem Solving

One of the projectors is not turned on, or the projectors have not been linked together

Check
Are the commander and receiver connected correctly with a USB
cable?
Is Stack Mode set to Off?
Has an error occurred in the commander?
Has an error occurred in the receiver?

Other Problems

No sound can be heard or the sound is faint

Check
Check that the audio/video cable is securely attached to both the
projector and audio source.
Connect the commander's USB(TypeA) port to the receiver's USB(TypeB) port with a USB cable. Also, check that the
USB cable is not disconnected.
Startup Guide
s
s "From Installation to Projection" p.32
Commander: Set Stack Mode to Commander.
Receiver: Set Stack Mode to Receiver.
s Extended - Operation - Stack Mode
If any errors occur in the commander, the receiver displays a warning message.
In this situation, the only available operation is to turn off the receiver. Press the [
turn off the receiver.
Stop using the commander, and contact your local dealer or the nearest address provided in the Epson Projector Contact
List.
Epson Projector Contact List
s
If you want to turn on the receiver only, hold down the [2] button on the remote control and then press the [t] button.
If any errors occur in the receiver, the commander displays a warning message.
In this situation, the commander can be operated as normal.
Stop using the receiver, and contact your local dealer or the nearest address provided in the Epson Projector Contact
List.
Epson Projector Contact List
s
If you want to turn on the commander only, hold down the [1] button on the remote control and then press the [t]
button.
Disconnect the cable from the Audio port, and then reconnect the cable.
Remedy
p.61
Remedy
78
] button on the remote control to