Resetting The Lamp Hours; Replacing The Air Filter; Air Filter Replacement Period; How To Replace The Air Filter - Epson EB-W16SK User Manual

Hide thumbs Also See for EB-W16SK:
Table of Contents

Advertisement

Replacing Consumables
When you have finished replacing the lamp, return the commander section
to its previous position, and then tighten the stacker angle adjustment
screws.
Caution
When returning the commander section, be careful not to trap your fingers in
the moving mounting sections.

Resetting the lamp hours

The projector records how long the lamp is turned on and a message and
indicator notify you when it is time to replace the lamp. After replacing the
lamp, make sure you reset the Lamp Hours from the Configuration menu.
"Reset Menu"
p.63
s
a
Only reset the Lamp Hours after the lamp has been replaced.
Otherwise the lamp replacement period is not indicated correctly.

Replacing the Air Filter

Air filter replacement period

If the message is displayed frequently even though the air filter has been
cleaned, replace the air filter.

How to replace the air filter

The air filter can be replaced even when the projector is suspended from a
ceiling.
This section explanation explains how to replace the commander's air filter.
Replace the receiver's air filter in the same way.
a
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cord.
b
Open the air filter cover.
Place your finger into the groove at the top of the air filter, and pull
it towards you.
c
Remove the air filter.
Grip the tab at the center of the air filer, and pull it towards you.
88

Advertisement

Table of Contents
loading

Table of Contents