Back Panel; Range Components; Side Access Panel - GE Monogram ZDP486ND Technical Service Manual

Back Panel

The back panel is attached with seventeen 1/4-in.
hex head screws. It is necessary to remove the
range from the installation to access the screws.
(See .)
Installation

Range Components

Side Access Panel

To remove the side access panel:
1. Remove the range from the installation. (See
Installation
2. Place the control panel in the service position.
(See
3. Remove the three 1/4-in. hex head screws that
attach the side panel to the rear of the range.
4. Remove the 2 Phillips-head screws from the
front of the side panel.
– 47 –
.)
.)
Control Panel
(Continued next page)